What Can’t You Design In SolidWorks?

February 25th, 2013 by

RC Hovercraft #1

For this blog series I wanted to design something from scratch.  Not necessarily a new idea but something fun and cool.  My intention is to design a Remote Control Hovercraft from the ground up.

I want to give you a brief description and history of a Hovercraft:

A hovercraft or air-cushion vehicle is a vehicle capable of travelling over variable surfaces, such as land and water.  The hovercraft operates by forcing a high pressure of air between the bottom of the craft and the surface below.  This high pressure of air lifts the vehicle upward essentially “hovering” above the ground on a cushion of air. The first practical design for hovercraft derived from several coinciding inventions in the 1950s to 1960s. They are now used throughout the world as specialized vehicles for transport and other applications.

500px-Hovercraft_-_scheme.svg

  1. Propulsion Propellers
  2.  Air
  3. Lifting Fan
  4. Flexible skirt

YouTube Preview Image

I have specific goals in mind that I want to meet in the design and build of this project.

 

Goals of the Hovercraft Design:

  • Utilize the SolidWorks and SolidWorks Simulation Suite of software to develop and optimize the hover craft design.
  • The RC Hovercraft’s main components will be 3D Printed using the Stratasys UPrint.
  • Easy to Assemble. I want to make the assembly as easy and as straight forward as possible with concise instructions.
  • For purchased components, use low cost, off the shelf components including the electric motors, electronic speed control (ESC), batteries, and propellers.

I am starting from just an idea, and a sketch. We will see where the design leads.

Hover Craft2

Robert Warren

Elite Application Engineer CAE Technical Specialist 3DVision Technologies

Tags: , , , , , , , ,

One Response to “What Can’t You Design In SolidWorks?”

  1. Gene Mercer says:

    Since you’re using the 3D printer, I’d maybe consider embedding some things (unless your goal is to produce later using standard manufacturing methods). For example: Have the fan blades/axles already in the protective guards.
    Or as a side experiment, create a smaller model. Rubber band powered but entirely made in 1 run of the 3D printer. (one or two fan design and a rudder) Might be a neat hand-out toy.

Leave a Reply


six − three =

Follow
Get every new post delivered to your inbox
Join other followers
Powered By WPFruits.com
Bear